RE: [ixp1200] Problem with programming the flash

Hi, Excellent Nawaz, I am happy that atleast one person has done it before. Erasing the chip was the first thing I tried. But it failed. There was an error message which simply said "Erase Error!". It passes the hardware test properly, so I guess there is nothing wrong in the device selection (which is "INTEL E28F800B3-B"). I am able to read from the device into buffer without any problem. I have tried with the front and back chips with the same result. Please can you tell me where I could be going wrong. Thank you, Regards, Sandeep. -----Original Message----- From: owner-ixp1200@CS.Princeton.EDU [mailto:owner-ixp1200@CS.Princeton.EDU]On Behalf Of Sarfraz Nawaz Sent: Saturday, June 15, 2002 7:13 AM To: ixp1200@CS.Princeton.EDU Subject: Re: [ixp1200] Problem with programming the flash I've the same equipment as yours and I've used it to program the flash a number of times. You have to first erase it and then write it.

From: Sandeep P Reply-To: ixp1200@CS.Princeton.EDU To: ixp1200@CS.Princeton.EDU Subject: [ixp1200] Problem with programming the flash Date: Fri, 14 Jun 2002 02:22:57 -0700

Hi All, I am currently trying to program IXP1200 flash with the Intel firmware. I am using flash burner equipment called Topmax which is from the company EEtools. Inspite of following the instructions as mentioned in the manual I am unable to write to the flash. Read from flash is successful, but writes are not happening. Have any of you faced a similar problem? Do I need to take some extra steps before writes are allowed? The device continuously makes attempts to write but in the end is unable to write anything.

Regards, Sandeep.

Research Assistant, Real-Time Embedded Systems Lab, Arizona State University, Arizona, U.S.A.

_________________________________________________________________ MSN Photos is the easiest way to share and print your photos: http://photos.msn.com/support/worldwide.aspx