Hi,
Initially even I faced this problem...but I
resolved it.Just define RF1812 in one of the microcode
files and your problem will be solved.
Ravi Modgekar
--- Charles Chiou
Hi,
This is not a VERA question per se, I apologize... However, I wonder if anyone has successfully used the pseudo-ethernet driver (peth.o) that comes with the IXA SDK 2.0 and run it on the C0 board with linux kernel 2.3.99? I followed the instructions and did the following:
$ insmod ue.o $ insmod octmac.o $ insmod giga_drv.o $ rs_udebug
then used the workbech to start a hardware debug session to upload the microcode (in the L3fwd16 project) to the target, and start the microengines.
$ load (and this installed the peth.o module and configured the net devices peth0 - peth7 with IP addresses 1.2.x.5)
I then connected port 0 of the slow ports to a workstation's network card with IP address 1.2.1.1 and tried to ping it from the SA linux shell. This is what I got:
$ ping 1.2.1.1
peth_start_xmit: new descriptor = a4 peth_start_xmit: pData = c1b15000 peth_start_xmit: len = 42, descFlags = 2901 peth_start_xmit: queue = 300, headTail = ffffffff peth_start_xmit: tail = ffff peth_start_xmit: new headTail = ffff00a4 peth_start_xmit: queueCount = -1 peth_start_xmit called peth_start_xmit: new descriptor = a0 peth_start_xmit: pData = c1b14800 peth_start_xmit: len = 42, descFlags = 2901 peth_start_xmit: queue = 300, headTail = ffffffff peth_start_xmit: tail = ffff peth_start_xmit: new headTail = ffff00a0 peth_start_xmit: queueCount = -1 peth_start_xmit called peth_start_xmit: new descriptor = 9c peth_start_xmit: pData = c1b14000 peth_start_xmit: len = 42, descFlags = 2901 peth_start_xmit: queue = 300, headTail = ffffffff peth_start_xmit: tail = ffff peth_start_xmit: new headTail = ffff0094 peth_start_xmit: queueCount = -1 peth_start_xmit called peth_start_xmit: new descriptor = 90 peth_start_xmit: pData = c1b12800 peth_start_xmit: len = 42, descFlags = 2901 peth_start_xmit: queue = 300, headTail = ffffffff peth_start_xmit: tail = ffff peth_start_xmit: new headTail = ffff0090 peth_start_xmit: queueCount = -1
...
peth_start_xmit called peth_start_xmit: new descriptor = 0 Bad descriptor 0, dropping outgoing packet pethFreeDescriptor: descriptor = 0 pethFreeDescriptor: Bad descriptor 0
Any suggestions is appreciated!
Thanks,
Charles
__________________________________________________ Do You Yahoo!? LAUNCH - Your Yahoo! Music Experience http://launch.yahoo.com