Shyamal,

fiirst configure the ethernet and loopback interfaces and then run rs_udebug.

--Ashish
Dept. of Computer Engineering
San Jose State University
San Jose, CA

In a message dated 12/13/2002 4:35:40 AM Pacific Standard Time, shyamalpandya@hotmail.com writes:

When I try running rs_udebug on an ENP-2505 board, it fails
with the following error:

Device lo is down.
Device lo is down.
Cannot register service: RPC: Unable to send; errno = No buffer space
available
unable to register (SA1200TARGET, SA1200VERSION, udp).

The ue.o, pciDg-arm.o and pciDgNet-arm.o modules are loaded.