Hi All, I'm new to this list and would like to find out a little more about the IXP 1200. I apologize if some of these questions have been asked before. I understand that it is possible to plug the eval board into the 33-MHz 32-bit PCI slot of a standard PC (after some jumper and firmware changes). 1. Can the host PC access the SDRAM, SRAM, registers, etc on the IXP 1200? Is using the IXP1200 in the PCI slot of a PC a supported mode of operation in the first place? 2. Can the StrongArm initiate a DMA transfer directly between its SDRAM and PC host memory? Any idea what is the rough performance is? 3. Can the StrongArm generate interrupts to the host PC over the PCI bus? 4. Can we really expand the SDRAM memory on the IXP1200 to 256MB as listed in the specs? Thanks very much! joon