Hi, Ping was not running. In fact the PC kind of hangs ie mouse pointer disappears etc when I connnect. I am able to see the output only after I disconnect. Configuration: Ethernet port 1 of ENP-2505 is connected back-to-back to the eth1 of the host PC ( PC in which the card is plugged in) through a crossover cable. The IP address of the IXP port is 192.168.1.150 and the IP address of the PC port is 192.168.1.3 . Also is there any option is the ixsys.config file through which I can specify the rate ? Thanks, Kamesh. Abhijeet Joglekar wrote:
Hi Kameswara,
I guess you have already tried to connect the PC port to the IXP port without going thro' the hub as Cyrus suggested. Just to rule out any autonegotiation problems betweem 10/100 hub and IXP port.
So is ping running when you captured that tcpdump output? Also, what are the interface addresses of the IXP port and the PC port in your setup?
-- abhijeet
On Thu, 3 Apr 2003, Kameswara Avasarala wrote:
Hi, This is what I observe if I do a tcpdump.
Cyrus Hall wrote:
Hi there-
You mention a great deal of link level activity. Have you done a TCP dump? I had my ENP-2505 hooked up to a 10 Mbps hub which was causing all sorts of issues, including a packet flood to be issued from the card whenever I tried to start up a uACE. Make sure all interfaces are 100 Mbps and see if that helps...