However, it still times out after a while and exits. Cannot register service: RPC: Timed out unable to register (SA1200TARGET, SA1200VERSION, udp). [1]+ Exit 1 ./rs_udebug I don't have a clue what to do... -- Shyamal Pandya Cogito, ergo sum! Addr: 920 S Terrace Rd #102 Tempe AZ 85281 Phone: 1-480-96601982

From: "Shyamal Pandya" Reply-To: ixp1200@CS.Princeton.EDU To: ixp1200@CS.Princeton.EDU Subject: Re: [ixp1200] rs_udebug fails Date: Sun, 15 Dec 2002 04:34:51 -0700

Ashish, Thanks! lo was not properly configured.

-- Shyamal Pandya

Cogito, ergo sum!

Addr: 920 S Terrace Rd #102 Tempe AZ 85281 Phone: 1-480-96601982

...

From: Rayashish@aol.com Reply-To: ixp1200@CS.Princeton.EDU To: ixp1200@CS.Princeton.EDU Subject: Re: [ixp1200] rs_udebug fails Date: Fri, 13 Dec 2002 13:10:43 EST

Shyamal,

fiirst configure the ethernet and loopback interfaces and then run rs_udebug.

--Ashish Dept. of Computer Engineering San Jose State University San Jose, CA

In a message dated 12/13/2002 4:35:40 AM Pacific Standard Time, shyamalpandya@hotmail.com writes:

...

When I try running rs_udebug on an ENP-2505 board, it fails with the following error:

Device lo is down. Device lo is down. Cannot register service: RPC: Unable to send; errno = No buffer space available unable to register (SA1200TARGET, SA1200VERSION, udp).

The ue.o, pciDg-arm.o and pciDgNet-arm.o modules are loaded.

_________________________________________________________________ Add photos to your e-mail with MSN 8. Get 2 months FREE*. http://join.msn.com/?page=features/featuredemail

_________________________________________________________________ The new MSN 8: smart spam protection and 2 months FREE* http://join.msn.com/?page=features/junkmail