Re: [ixp1200] Re:ENP 2505 Installation
![](https://secure.gravatar.com/avatar/fad33f1d81adee96c218c0a90741b7aa.jpg?s=120&d=mm&r=g)
hello Banit,
I will switch over to Linux release 7.2
Thanks for the pointer.
-Darshan
----Original Message Follows----
From: Banit Agrawal
Hi, I am a novice in the area of network processors. Currently, i am installing the ENP 2505 IXP 1200 Network Processor board on a Linux Release 9 with Windows Emulator [Wine]on it. I have the minicom configured to Baud Rate-38400 Data Bits- 8 Stop Bits-1 Parity-None and no hardware and software flow control. I have the DIP 1301 switch on the ENP 2505 network processor board set to boot the Boot Manager. 1.When i boot the system i still don't get the BootMgr prompt in the minicom? Any suggestions? Thanks,
-Darshan
_________________________________________________________________ Wonder if the latest virus has gotten to your computer? Find out. Run the FREE McAfee online computer scan! http://clinic.mcafee.com/clinic/ibuy/campaign.asp?cid=3963
-- - ================================================================== Banit Agrawal Graduate Student Researcher Department of Computer Science (909)-787-2001 UC, Riverside bagrawal@cs.ucr.edu CA, 92521 http://www.cs.ucr.edu/~bagrawal ================================================================== _________________________________________________________________ Dont worry if your Inbox will max out while you are enjoying the holidays. Get MSN Extra Storage! http://join.msn.com/?PAGE=features/es
participants (1)
-
Darshan Uka