Hi I installed and set up the board (ixp1200),I used linux, vmware and sdk workbench 2,0 , and ran examples tutorial 1 and 2, all ok. I want to run a proyect from workbench, load code in ue. I realized 1- boot board ./bootixp 2- in /nfs/ixasdk/bin /arm-be insmode ./ue.o ./rs_debug & mknod /dev/octMac0 c 10 0 mknod /dev/octMac1 c 10 1 mknod /dev/octMac2 c 10 2 mknod /dev/octMac3 c 10 3 insmod --force ./octmac.o minorStart=0 mac0="a0:00:00:b0:00:00" mac1="c0:00:00:00:d0:01" mac2="e0:00:00:00:f0:02" mac3="50:00:00:0d:00:03" 3- open in Vmware Sdk 2.01 my proyect - check in menu debug harware - in menu hardware options conect via ethernet 192.168.0.2 4 - start debuging After at all, conect packet generator to port 0 in the output there are not packets (port 1) is it correct to run aplication in this form? I want tu run an load proyect in board from sdk what is the procces? att Karen Saenz