[ixp1200] bridalveil+linux+peth+L3f

[Istvan Matyasovszki]

Hi,
I have
cygmon ver: 2.04
cpu: ixp1200 rev. C0
board: intel pa1104

Dip switches:

SW0201    1  2  3  4
          ON ON ON ON

SW1301    1   2   3  4  5  6  7  8
          OFF OFF ON ON ON ON ON ON

-istvan
          
rm> hi,
rm>    Can you give me the configuration of Bridalveil
rm> board.It may help me to analyse the problem.
rm> Ravi
rm> --- Istvan Matyasovszki <istvan.matyasovszki at ul.ie>
rm> wrote:
>>   Hi,
>> 
>>   I'm trying to run/debug the L3 forwarding
>> reference design on
>>   an Bridalveil board (with driver ver. 1.4).
>>   The ue.o,peth.o,octmac.o,rs_udebug and rtmapp
>> files
>>   are from IXA Kit ver 2.01 (as the ue.o supplied
>> with the ramdisk conflicts
>>   with the latest rtmapp supplied with SDK 2.01).
>>   
>>   After starting the hardware debug from the ixp1200
>> developer
>>   workbench in about 5 seconds I either get a frozen
>> bridalveil
>>   board
>> 
>>   (" Get Microengine Status failed due to remote
>> service timeout.
>>            ...
>>      To proceed, stop debugging and reboot the
>> chip.")
>> 
>>   and a frozen hub or an error from the board
>> 
>>   "Bad descriptor fffffb00, dropping outgoing packet
>>    pethFreeDescriptor: Bad descriptor fffffb00"
>> 
>>   and after a minute or so the board is frozen and
>> the hub in which is
>>   plugged-in is frozen too.
>>   
>>   Could you please give me an advice ? Has anybody a
>> working example
>>   that uses the L3f reference design ?
>> 
>>   Thank You
>>   -istvan
>> 


rm> __________________________________________________
rm> Do You Yahoo!?
rm> Yahoo! Tax Center - online filing with TurboTax
rm> http://taxes.yahoo.com/