[ixp1200] WorkBench in HARDWARE Mode?

[Ye, Irvin]

Thanks!

-----Original Message-----
From: Abhijeet Joglekar [mailto:abhijeet at cs.utah.edu]
Sent: 21 November 2002 13:33
To: 'ixp1200 at cs.princeton.edu'
Subject: Re: [ixp1200] WorkBench in HARDWARE Mode?


Irvin,

There was some discussion about this in August 2002 on this mailing list.
Try looking in the archives to see if that is useful to you.

-- Abhijeet

On Thu, 21 Nov 2002, Ye, Irvin wrote:

> Hi,
>
> Now, I meet problems in using WorkBench in HARDWARE mode. The microcodes have
> been successfully loaded and ran, but failed to get any packets from the
ports.
> The same examples from Intel, if run out of WorkBench, it can receive packets
> from the ports; but if run in WorkBench, it fails. I've checked the
> correspondent registers, eg, RCV_RDY_LO. The value sounded abnormal in the
> later case. So, does it mean that ports or FBI and like stuffs are not
> properlly configured in WorkBench. Those honorable veterans, who can give me
> some hints?
>
> Thank in advance!
>
> Irvin
>
>
>