[ixp1200] l3fwdr

[Kameswara Avasarala]

Hi,
       I have the configuration described below
ENP-2505
eth1  192.168.1.150    connected to the 192.168.1.0 subnet through a 
hub. I am trying to ping a host 192.168.1.3 from the ENP-2505 and also 
the ENP-2505 from the host 192.168.1.3 . I am unable to do either . 
Although as I have said earlier there seems to be a lot of link level 
activity going on.
Thanks,
Kamesh.

Nimit S Sawhney wrote:

>Not being able to ping could be due to incorrect routing
>table entries on the host linux end. You might want to check
>those out...(I am assuming u r trying to ping from the host
>to the ENP's port)
>-N
>
>----- Original Message ----- 
>From: "Kameswara Avasarala" <venkata at acad.umass.edu>
>To: <ixp1200 at CS.Princeton.EDU>
>Sent: Tuesday, April 01, 2003 10:57 AM
>Subject: Re: [ixp1200] l3fwdr
>
>
>  
>
>>Hi,
>>      I invoked ixstart with ixsys.config-sys-l3fwdr as the parameter. I 
>>could see that all the ace's and microaces are being loaded. The number 
>>of interfaces created was 1 since I commented out the extra entries in 
>>the config files, still I am unable to ping. However I see a lot of 
>>activity from the ethernet port. The  led on the hub to which the 
>>ENP-2505 ethernet port is connected is blinking away furiously.
>>Thanks,
>>Kamesh.
>>
>>Nimit S Sawhney wrote:
>>
>>    
>>
>>>Renaming to ixsys.config is not a good idea
>>>since the original file is also needed. You can
>>>comment out the extra interfaces in the file
>>>"ixsys.config-sys-l3fwdr" since you have
>>>have only 4 ports on your ENP2505. 
>>>
>>>-Nimit
>>>
>>>      
>>>
>
>
>  
>