[ixp1200] Question on setup ENP2505, urgen (fwd)
Feng Tang
ftan413 at cse.unsw.edu.au
Tue May 20 01:24:49 EDT 2003
Hello, all
Sorry to trouble you. But I do hope to solve my problem quickly, since I
have waste much much time on it yet. I am using the ENP2505 board. When I
tried to setup it, I met the problems.
After I run the .ixstart, it inside invoked create_enivronment.rc and
boot_bv before the system enter embedded linux by my thought.
Here, create_environment.rc has no any problems, because it is very
simple. But, when boot_bv finished running here, I got the below
information which was recored in the boot_bv.log.
" [root at cordelia bin]# cat boot_bv.log
eth1: unknow interface: No such device
rmmod: module pciDgNet is not loaded
rmmod: module pciDg is not loaded
insmod: a module named bv already exists
(null): unable to open device '/dev/bv'
encountered system error 2: No such file or directory
rmmod: module bv is not loaded
[root at cordelia bin]#
"
" [root at cordelia bin]# cat boot_bv
./unload_pciDg
./load_bv
./bvloadapp
./unload_bv
[root at cordelia bin]#
"
I thought my boot_bv should run inproperly, otherwise the system won't
stop until a message appear after the cygmon prompt.
" cygmon> .ixstart global time out
"
Do you think the problem is I install the enp driver incorrectly or
something else? But I thought I have re-install the whole system more than
20 times. It' impossible I always make the same mistakens here. By the
way, do you think my PC's pci does not compatible with this enp board?
best,
feng
More information about the ixp1200
mailing list