Shyamal, fiirst configure the ethernet and loopback interfaces and then run rs_udebug. --Ashish Dept. of Computer Engineering San Jose State University San Jose, CA In a message dated 12/13/2002 4:35:40 AM Pacific Standard Time, shyamalpandya@hotmail.com writes:

When I try running rs_udebug on an ENP-2505 board, it fails with the following error:

Device lo is down. Device lo is down. Cannot register service: RPC: Unable to send; errno = No buffer space available unable to register (SA1200TARGET, SA1200VERSION, udp).

The ue.o, pciDg-arm.o and pciDgNet-arm.o modules are loaded.