[ixp1200] rs_udebug fails

[Shyamal Pandya]

However, it still times out after a while and exits.

Cannot register service: RPC: Timed out
unable to register (SA1200TARGET, SA1200VERSION, udp).
[1]+  Exit 1                  ./rs_udebug


I don't have a clue what to do...



--
Shyamal Pandya

Cogito, ergo sum!

Addr:
920 S Terrace Rd #102
Tempe AZ 85281
Phone:
1-480-96601982





>From: "Shyamal Pandya" <shyamalpandya at hotmail.com>
>Reply-To: ixp1200 at CS.Princeton.EDU
>To: ixp1200 at CS.Princeton.EDU
>Subject: Re: [ixp1200] rs_udebug fails
>Date: Sun, 15 Dec 2002 04:34:51 -0700
>
>Ashish,
>Thanks!
>lo was not properly configured.
>
>
>
>--
>Shyamal Pandya
>
>Cogito, ergo sum!
>
>Addr:
>920 S Terrace Rd #102
>Tempe AZ 85281
>Phone:
>1-480-96601982
>
>
>
>
>
>>From: Rayashish at aol.com
>>Reply-To: ixp1200 at CS.Princeton.EDU
>>To: ixp1200 at CS.Princeton.EDU
>>Subject: Re: [ixp1200] rs_udebug fails
>>Date: Fri, 13 Dec 2002 13:10:43 EST
>>
>>Shyamal,
>>
>>fiirst configure the ethernet and loopback interfaces and then run 
>>rs_udebug.
>>
>>--Ashish
>>Dept. of Computer Engineering
>>San Jose State University
>>San Jose, CA
>>
>>
>>In a message dated 12/13/2002 4:35:40 AM Pacific Standard Time,
>>shyamalpandya at hotmail.com writes:
>>
>>
>> > When I try running rs_udebug on an ENP-2505 board, it fails
>> > with the following error:
>> >
>> > Device lo is down.
>> > Device lo is down.
>> > Cannot register service: RPC: Unable to send; errno = No buffer space
>> > available
>> > unable to register (SA1200TARGET, SA1200VERSION, udp).
>> >
>> >
>> > The ue.o, pciDg-arm.o and pciDgNet-arm.o modules are loaded.
>> >
>> >
>> >
>>
>
>
>_________________________________________________________________
>Add photos to your e-mail with MSN 8. Get 2 months FREE*. 
>http://join.msn.com/?page=features/featuredemail


_________________________________________________________________
The new MSN 8: smart spam protection and 2 months FREE*  
http://join.msn.com/?page=features/junkmail