[ixp1200] rs_udebug fails

[Shyamal Pandya]

Ashish,
Thanks!
lo was not properly configured.



--
Shyamal Pandya

Cogito, ergo sum!

Addr:
920 S Terrace Rd #102
Tempe AZ 85281
Phone:
1-480-96601982





>From: Rayashish at aol.com
>Reply-To: ixp1200 at CS.Princeton.EDU
>To: ixp1200 at CS.Princeton.EDU
>Subject: Re: [ixp1200] rs_udebug fails
>Date: Fri, 13 Dec 2002 13:10:43 EST
>
>Shyamal,
>
>fiirst configure the ethernet and loopback interfaces and then run 
>rs_udebug.
>
>--Ashish
>Dept. of Computer Engineering
>San Jose State University
>San Jose, CA
>
>
>In a message dated 12/13/2002 4:35:40 AM Pacific Standard Time,
>shyamalpandya at hotmail.com writes:
>
>
> > When I try running rs_udebug on an ENP-2505 board, it fails
> > with the following error:
> >
> > Device lo is down.
> > Device lo is down.
> > Cannot register service: RPC: Unable to send; errno = No buffer space
> > available
> > unable to register (SA1200TARGET, SA1200VERSION, udp).
> >
> >
> > The ue.o, pciDg-arm.o and pciDgNet-arm.o modules are loaded.
> >
> >
> >
>


_________________________________________________________________
Add photos to your e-mail with MSN 8. Get 2 months FREE*. 
http://join.msn.com/?page=features/featuredemail