[ixp1200] Problem with programming the flash

[Scott C. Karlin]

I have no specific advice.  You can try:
(1) make sure there are no bent pins on the device(s)
(2) make sure that you are specifying the correct part number
    to the device programmer.
(3) make sure the software for the programmer (if there is
    software) is up to date.
In the end, you'll probably need to consult with EEtools.

Scott


On Fri, Jun 14, 2002 at 02:22:57AM -0700, Sandeep P wrote:
> Hi All,
>       I am currently trying to program IXP1200 flash with the Intel
> firmware. I am using flash burner equipment called Topmax which is from the
> company EEtools. Inspite of following the instructions as mentioned in the
> manual I am unable to write to the flash. Read from flash is successful, but
> writes are not happening. Have any of you faced a similar problem? Do I need
> to take some extra steps before writes are allowed? The device continuously
> makes attempts to write but in the end is unable to write anything.
> 
> Regards,
> Sandeep.
> 
> Research Assistant,
> Real-Time Embedded Systems Lab,
> Arizona State University,
> Arizona, U.S.A.