[ixp1200] l3fwdr

[Jimmy Brian Christanthio]

Try rebooting the machine. 

-----Original Message-----
From: owner-ixp1200 at CS.Princeton.EDU
[mailto:owner-ixp1200 at CS.Princeton.EDU] On Behalf Of Nimit S Sawhney
Sent: Wednesday, April 02, 2003 1:47 AM
To: ixp1200 at CS.Princeton.EDU
Subject: Re: [ixp1200] l3fwdr


Try running "tcpdump" on the host 192.168.1.3 and confirm
if the ping packet is actually reaching it. If it is, then you have a
wrong route entry in the host's RT. If it is not, then
- try not using the hub
- double check all the connections/ports to and from the hub

cheers,
-N

----- Original Message -----
From: "Kameswara Avasarala" <venkata at acad.umass.edu>
To: <ixp1200 at CS.Princeton.EDU>
Sent: Tuesday, April 01, 2003 12:28 PM
Subject: Re: [ixp1200] l3fwdr


> Hi,
>        I have the configuration described below
> ENP-2505
> eth1  192.168.1.150    connected to the 192.168.1.0 subnet through a
> hub. I am trying to ping a host 192.168.1.3 from the ENP-2505 and also

> the ENP-2505 from the host 192.168.1.3 . I am unable to do either . 
> Although as I have said earlier there seems to be a lot of link level 
> activity going on. Thanks,
> Kamesh.
>
> Nimit S Sawhney wrote:
>
> >Not being able to ping could be due to incorrect routing table 
> >entries on the host linux end. You might want to check those out...(I

> >am assuming u r trying to ping from the host to the ENP's port)
> >-N
> >
> >----- Original Message -----
> >From: "Kameswara Avasarala" <venkata at acad.umass.edu>
> >To: <ixp1200 at CS.Princeton.EDU>
> >Sent: Tuesday, April 01, 2003 10:57 AM
> >Subject: Re: [ixp1200] l3fwdr
> >
> >
> >
> >
> >>Hi,
> >>      I invoked ixstart with ixsys.config-sys-l3fwdr as the 
> >>parameter. I could see that all the ace's and microaces are being 
> >>loaded. The number of interfaces created was 1 since I commented out

> >>the extra entries in the config files, still I am unable to ping. 
> >>However I see a lot of activity from the ethernet port. The  led on 
> >>the hub to which the ENP-2505 ethernet port is connected is blinking

> >>away furiously. Thanks, Kamesh.
> >>
> >>Nimit S Sawhney wrote:
> >>
> >>
> >>
> >>>Renaming to ixsys.config is not a good idea
> >>>since the original file is also needed. You can
> >>>comment out the extra interfaces in the file 
> >>>"ixsys.config-sys-l3fwdr" since you have have only 4 ports on your 
> >>>ENP2505.
> >>>
> >>>-Nimit
> >>>
> >>>
> >>>
> >
> >
> >
> >
>
>
>
>