[ixp1200] Question on enp-2505

[Yong Liu]

the new interface is provided by pciDgNet.o, see file bin/start_pcidg,
------------------------------
file bin/start_pcidg :
 insmod ./pciDg.o
 insmod ./pciDgNet.o
 ifconfig eth2 192.168.0.4
------------------------------

bv.o is the first module used to load Linux kernel and the basic file system
to the ixp board.

Below is the output of "dmesg"(command to show kernel debug info) realted to
ixp_board on my machine.

--------------------------------------------------------------------
bv: MEM 0xB0000000..0xBFFFFFFF  256M
PCI mem base is 0xB0000000
PCI mem window size is 0xFFFFFFF
bv: base remap address is 0xC8842000
 dev->dev_mem is 0xc8842000 off is 0x4008000
 dev->dev_mem is 0xc8842000 off is 0x4800000
 dev->dev_mem is 0xc8842000 off is 0x4007ff0
un memory region
releasing memory region
disabling the pci device
Unregistering device bv
pciDg: Probing i21555 device.
pciDg:   Card, Slot/Function: 0, 14/0
PCI: Found IRQ 11 for device 00:0e.0
PCINetDev: init_module loaded at address 0xd8947060



----- Original Message ----- 
From: "Feng Tang" <ftan413 at cse.unsw.edu.au>
To: <ixp1200 at CS.Princeton.EDU>
Sent: Monday, May 26, 2003 9:32 PM
Subject: Re: [ixp1200] Question on enp-2505


> Hi, Yong Liu,
> I am confused whether the linux kernel has been located in enp2505 board
> before it goes out of the factory, or we still need to download the kernel
> into board using boot_bv script?
>
> after I run the boot_bv, I can got below information: