[ixp1200] rs_udebug fails

[Rayashish at aol.com]

Shyamal,

fiirst configure the ethernet and loopback interfaces and then run rs_udebug.

--Ashish
Dept. of Computer Engineering
San Jose State University
San Jose, CA


In a message dated 12/13/2002 4:35:40 AM Pacific Standard Time, 
shyamalpandya at hotmail.com writes:


> When I try running rs_udebug on an ENP-2505 board, it fails
> with the following error:
> 
> Device lo is down.
> Device lo is down.
> Cannot register service: RPC: Unable to send; errno = No buffer space 
> available
> unable to register (SA1200TARGET, SA1200VERSION, udp).
> 
> 
> The ue.o, pciDg-arm.o and pciDgNet-arm.o modules are loaded.
> 
> 
> 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://lists.cs.princeton.edu/mailman/private/ixp1200/attachments/20021213/ceb0ebb5/attachment.htm